Lowering your Audi A3 (8L) 1.8T S3 Quattro or Audi A3 (8L) 1.8T/1.9TDi Quattro will increase rear negative camber quite significantly. This negative camber causes excessive tyre wear normally on the inside edge of the rear tyres. The lower you go the more the negative camber increases and the worse the tyre wear becomes.
The Audi A3 (8L) Quattro platform sits low from the factory with slight negative camber as standard but drop it further than 30mm on lowering springs or coilovers and the rear independent wishbone suspension suffers from excessive negative camber.
The Stance+ Camber Adjustable Rear Control Arms allow you to neutralise the excessive negative camber and bring the tyre back in line with manufacturers settings, ensuring a perfectly flat tyre contact patch with the road.
Fitting takes around twenty minutes a side, and you keep the lowered look without damaging and scrubbing the tyres.
Worth doing on any Audi A3 (8L) Quattro platform car running more than a 30mm drop, and pretty much mandatory on a coilover equipped car running 40mm or lower.
The heavy-duty rubber bushes also tighten up rear-end response, so the car feels sharper through quick directional changes. Built tough enough for fast road and the occasional track day, with a powder-coated finish that stands up to British winters.
These Stance+ Camber Adjustable Rear Control Arms / Stance+ Camber Adjustable Rear Tie Bars are suitable for: Audi A3. (8L). (1996-2003). Engines: 1.8T, 1.8T S3, 1.9TDi. Hatchback. Quattro.
